You can say that about a lot of technologies. People in general underestimate how much labor life required even a century ago.
Imagine moving every gallon of water for cooking, cleaning, and bathing by hand before piped water? That’s about 9,000 gallons of water and 7 tons of coal for an average US household in 1890.
Even before industrialization a two horsepower watermill or windmill could replace the labor of 30-60 grinders. IIRC spinning machinery alone freed up 60 woman-days a year of labor for the average family. The most basic things took tons of labor before mechanization and electrification.
If you don't have pipe, your lifestyle changes. You don't take shower every day, you do it like once a week. You don't necessarily move water to your clothes, you might move you clothes to something like river and wash them there. So the comparison is not necessarily correct. Of course once you have cheap and available water, you adapt your life with that in mind.
Of course your general point valid. There was a lot of labor that civilization freed us from.
Laundry day is returning to '8 hours' here in Europe with our eco this eco that. 2.5 hours for a large washing load, nearly 3 hours in the heat pump dryer. Multiple loads and the queue for the dryer starts backing up and before I know it I'm making the bed at 9pm
A lot of eco (but not all) is just about reducing peak power draw so everything just takes longer. If you've got the space and money, people buy two washers and two dryers!
I'm being a bit dishonest of course because I'm sitting on my arse drinking tea when the machine is on so it's not quite the same
You can always use a quick program. It would use more energy and less time. My dishwashing machine can wash and dry dishes in one hour, comparing to almost four hours in eco mode. My washing / drying unit can do the whole washing/drying cycle in just three hours, as compared to almost four hours for just a wash in eco mode. Personally I use both modes, depending whether I am in hurry or not.
It's funny on a site with many engineers that many people believe there's a no-tradeoff option: the 'quick' option in the manual is described at being suitable for half loads, and it shows the suggested kg max about 50-60% of a normal load, on the selection of each mode, to re-inforce it.
The 'quick' cycle does seem good enough some of the time but it does ago against the recommendation
> I'm being a bit dishonest of course because I'm sitting on my arse drinking tea when the machine is on so it's not quite the same
When some 'labour saving' device is invented we started using it, and instead of enjoying the newly found time for leisure, we often go do some other labour that is on the TODO list.
You know, I still haven't tried it. That's been on my to-do list for awhile now. I really like Samba (and used it as my homelab CIFS server for years) but I never explored the AD Domain Controller functionality.
I definitely need to give it a shot. I'd love to get rid of Windows Server at home and use it as PoC for doing the same at Customer sites.
I wish I could live w/o Active Directory but, even at home, my threshold for Windows machines I'll tolerate administering w/o Group Policy is "any more than zero".
BTW, assuming you're who your HN username makes me think you are: Thanks for all your work on Samba. I've used the hell out of it at home and with Customers for at least two decades.
I use Samba AD as the basis for SSO on my home network that has every major OS, and once it's running it's fine. There's a couple of gotchas (don't use SSSD, use winbind for PAM on Linux machines for example, and make sure your reverse DNS actually works), but honestly the biggest problem I've found was that a lot of the information out there is either Samba3 related, or assumes you are not using the AD tools
The advent of for AI coding has meant that I can now start building a bunch of those Quality of Life tools[0] to help set up and maintain the Samba domain. I've a few that are good for daily usage, and a couple in the works for the initial setup which aren't yet ready for public consumption.
When governments (or anyone) wants to sell bonds, the money has to already exist 'in the wild'. The selling of government bonds does not create new money/currency. The pool(s) of money is already out there, and when bonds are offered, the people who control the pool(s) decide whether to buy or not.
(This isn't to deny that government deficits/debt needs to be at reasonable levels.)
I was being imprecise, it's not literally making up the entire deficit with new money, though the Federal Reserve's securities did increase by $200B over the past year, and M2 money supply increased by $1.2T. A lot of the deficit is inflationary in that it adds to the financial balance sheets of the private sector, even when financed by bonds sold to non-banks. It pushes up aggregate demand even when it doesn't increase the money supply. When aggregate supply can't keep up, you get inflation.
> And in the end you have a market where nobody has any basis for thinking anything has any value, and the market ends up being a random walk.
Companies have value: at the very least they can be liquidated and their assets sold off (book value). They also tend to generate profits and may choose to distribute them (dividends, share buybacks): this also has value to shareholders.
Where the random walk comes in is that the information of how healthy or profitable a company is gives it a (perceived) value of $x. But new information can be learned at any point about the company which can change the (perceived) outlook of its health and profitability, which may give it a value of $y. Now it could be that x>y or x.
It is the fact that this new information (real, rumoured, fake) can come at any random point in the future:
Book value is pretty much irrelevant unless your business is buying businesses and dismantling them for parts (vulture capitalism). A company's true value can also be less than its asset value because the dismantling process can be costly.
Yes we were talking about the stock market, surprised you forgot. As to which market, they are mostly correlated nowadays. A crash in the US affects the entire world, as we saw in 2008.
Your goals, timeline, and risk profile should determine the contents of your portfolio.
So glad we've established it's not as simple as 'buy VWRL' or similar.
It is as simple as I suggest, and most people should not invest in individual stocks:
I don't think it's quite that simple, because so many people invest in indexes, they are now being gamed by adjusting rules for early inclusion and gaming market cap by releasing only 5% of share initially, so that for example if you invest in indexes like NASDAQ, you'll be forced to take on massive risk in SpaceX and Anthropic right after IPO. Then there are other stocks like Nvida or Apple in which it's heavily overweight - the top 10 holdings are FIFTY percent of this index.
This concentration risk in market-cap weighted indexes is real and increasing at present.
So while I agree with you normally an index (though combined with bonds and cash) is a good choice for most people, at peaks of mania, just buy the index and it'll always recover is not always good advice.
* https://en.wikipedia.org/wiki/Washing_machine
"Laundry day" used to be the entire day, 8(+) hours.
reply