Yes, but code can be presented in different ways. This depends of course to a degree on the submitter (large changeset touching a lot of files or smaller change sets building upon each other?) but also could be presented differently (highlighting changes to data structures, identifying core parts of code and helper routines - lots of room for imagination)
Also mind: one doesn't only have to review changes code, but also review what hasn't been changed (are preconditions of other code still met?)
I've been trying to auto generate diagrams on PRs I'm reviewing. Flows changes via sequence diagrams, state changes and schema changes, post it to the PR with a skill. Then look at the relevant code based on the diagrams. Then \code-reviews. Moderately helpful. YMMV
I live in an area prone to high winds and we occasionally have pre-planned power shutdowns (I think PSPS is the term).
My Ioniq 5 has been a godsend. No, it can't power the house without dorking around with my electrical panel. But we can run the fridge, dishwasher, a few standing lights and keep phones and computers full charged.
I used a similar setup to Alex's but with the outlet in the rear seat instead of the V2X connector. I will probably by the V2X connector since it supposedly hanldles higher power draw.
That was my initial thought. But after 18 hours of running lights and fridge the car still had over 90% charge. So I saved myself the hassle of hand washing.
It’s only me and my partner and we run it every single day. To be fair we both work from home so we generate more dishes than two people that go to work I suppose but I just hate doing them by hand
2.5kWh seems like a lot to wash some dishes when some European models (which use cold fill) can go as low as 0.6 kWh.
The difference is mostly to use as little water as possible - just enough to wet the surface of the dishes not to soak them, and heat only the wash water not the 2 sets of rinse water or the prewash water.
There are some neat tricks to do this - for example there is no water level sensor - you aren't aiming to fill the bottom of the machine - instead you run the pump at full speed and keep adding water slowly till the pump electrically feels like it doesn't have many air bubbles in it.
> US models approx 2-3 kWh because energy efficiency laws are nowhere near as strict, and they use hot fill of usually electrically heated water.
Citation needed on this entire comment? Because cruising youtube and energystar.gov this energy use doesn't track. Like my bosch series seems basically the same as the EU one.
>they use hot fill of usually electrically heated water.
The US is a big freaking place. In my part of texas most houses have a nat gas access and most folks use gas water heaters because our water is incredibly hard.
I think a really in-depth look at how people use dishwashers would be pretty interesting. There are a lot of surprisingly strong opinions about right ways to do it. Of course knowing the right way is also interesting, but how people came to be so convinced that their way was the right way would be even more interesting to me-- I suspect there are a lot of hidden generational and socioeconomic attitudes hidden in there.
>suspect there are a lot of hidden generational and socioeconomic attitudes hidden in there
You're probably right about that. A lot of people grew up without dishwashers and don't have a way to economically install one outside of a major kitchen remodel even if they have the space which many in cities don't have. They're also not the, for lack of a better term, necessities that washers, stoves, and ovens are. And, of course, dishwashers don't eliminate the need for any handwashing and if you aren't cooking or doing a lot of entertaining a lot, they may not be all that useful. I do cook but still probably only run my dishwasher 2 or 3 times per week.
They completely eliminate the need for handwashing for me, unless cooking something very out of the ordinary like a huge vat of soup to freeze in the largest stock pot I own.
I have a rule that every single item in the kitchen goes into the dishwasher. If it doesn’t survive oh well - survival of the fittest.
The only thing exception outside of size that I can think of are the fancy knives. But we have an everyday set I don’t mind dulling and just sharpening once a month with a basic sharpener.
Everything used immediately goes into the dishwasher during the day, then before bed it gets ran full or not. Dishes put away with morning coffee and the cycle repeats. No dirty dishes cluttering up the kitchen, and no wasteful (water and time) hand washing required.
Yeah, though I tend to find that filling up a dishwasher with mostly a few things is often less efficient than just washing the bulky/awkward things by hand.
I was going to make a joke about ludicrous speed, but then remembered that automatic dishwashers for restaurants typically clean dishes in under two minutes.
Some cemeteries require a vault. The problem they'll face with no vault is the ground will depress there as things decay, and they want to get grass growing there ASAP and not have to worry about leveling things out all the time. But many cemeteries will allow it and will just heap the dirt a little higher so it settles more evenly eventually.
Our church does most of the work preparing the body for our parishioners. We have a group that goes to clean and dress the body, then brings it to the church in a simple coffin with dry ice until the funeral and burial. Frequently the only thing the family has to pay for is for coffin (the church keeps one or two on hand that the family can buy at cost) and the cemetery to dig a whole in the ground (we're not quite hardcore enough to do that b hand). We do insist on burial because we see cremation as disrespectful to human bodies that are created in the image of God, but usually use a simple wooden coffin and no vault if allowed by the cemetery, and no embalming if the family wants the members of the church to prepare the body.
I used to work for an IoT connectivity provider (think SIM cards, eUICC etc); I know that some of the manufacturers of various devices have been investigating adding cellular and soldered eUICC (ostensibly for diagnostics, warranty etc).
So it's not even that it won't be long; I'm sure they already have designs and are just waiting for eUICC support to catch up.
Then they'll quickly discover how bad cell coverage is in vast swathes of the USA and they'll have to be a lot more tolerant of bad customer sat scores and high return rates than they typically want to be.
Vehicles already have them, you don't need a lot of bandwidth just enough data to identify the members household which can be done with a wifi access point map and bluetooth MACs.
In a previous position, we used Adobe Connect a lot for online meetings, and the normal way of sharing presentations was to upload them to the room and control the presentation from there.
Webex has this as well, but I find that most people don't bother and just share their screen.
reply