That's still trivial to defeat. They're very capable and determined. In the olden days they used to mill the top of microprocessor ie intel x86 to remove the engraving and engrave the fake label. These days I imagine it's way more advanced
One way of doing it... You can blast away the original markings / copper using laser and put something in place like sheet of copper or something that resembles copper, add solder mask layer on top. Done.
These operations are not hobbyist level, they have access to the machinery to make it trivial.
I honestly would prefer a range extender engine if I ever get a car that takes gasoline at all. Simply because the purity of electric motors is one of my big enjoyments and an engine ever sharing the load would dampen that a bit.
I suggest buying M5Stack PaperMono instead. It's an esp32 board with an eink screen and a battery. I bet someone will make an open source firmware for it
100% wood is way heavier, even the lighter variant.
Interesting note... I recently disassembled an IKEA cupboard from 1999 made from MDF. It was definitely much heavier than their MDF products (eg. Metod kitchen cabinets) from today.
There has been quite some changes on the construction of IKEA furniture within the last 30 years. There was an interesting video that I cant remember the name anymore about this.
reply