HN Simulatornew | past | comments | lists | submit | gcr's commentslogin

How would you differentiate between currency influence and power influence?


Power is being able to get people to do things you want them to do. It's become clear that you can do that a lot better with stocks than within currency, although you can also do it with a huge amount of currency.


OP means that some WiFi antennae are soldered to the motherboard and cannot be easily removed.

When building my PC, I got a PCI WiFi card but it turns out there was also a direct WiFi network interface built into the motherboard somehow


They would be traces with pretty obvious patterns and easy to cut.

But I don't the GP comment was talking about that; I have also used WiFi without an antenna (PCB or otherwise), and it was also slow for me.

A dummy load is probably the best idea: an impedance mismatch would obliterate any chance of anything working (including Bluetooth fwiw).


The point of a dummy load is to match the impedance so that all the radiative energy gets turned into heat and the transmitter is none the wiser.


Also so that any electronics don't get fried. Wi-fi board borking itself would be good, but I'd be worried about it affecting something else down the line.


Exactly. That's part of what I meant by "none the wiser." The other being that the xmitter could in theory detect a missing antenna from the impedance mismatch and try to increase its power (assuming it knows how to do so without frying itself).


"(assuming it knows how to do so without frying itself)."

Unlikely, as Wi-Fi is flea power (not high enough to do damage). Moreover, Wi-Fi chips have an inbuilt power limit so as to comply with spectrum management regulations.

Anyway, why wouldn't you want to fry the Wi-Fi chip if possible, that'd solve everything? If I had that problem I'd simply stuff the chip or short out its RF output (bridge solder across its antenna pins).

There are multiple ways of fucking the chip, likely the easiest is shorting B+ to the high side of its antenna pins (that'll likely do the trick). Another method is to hold the tip of a hot soldiering iron on the center of the chip until it fails.

Of course, you shouldn't do this unless you know what you are doing. The Wi-Fi chip may also control Bluetooth so if you still want that risky comms pathway then consult the chip's datasheet first.


> why wouldn't you want to fry the Wi-Fi chip if possible

The TV might throw an conniption over loss of this critical functionality.


And also, a dummy load prevents the feed line to the antenna from radiating due to the mismatch, itself acting as an antenna.

And for WiFi a simple 50 ohm resistor of 1/4 watt should be more than enough.


Wouldn't reflections be worse (genuinely asking)?


No. Reflections happen with unmatched impedance.


RF wireless always needs an antenna somewhere - https://news.ycombinator.com/item?id=50333679

If you know what you are doing and have explicitly disconnected/cut all antennas including entire MIMO arrays (many people miss one or more antennas) in the motherboard then the only remaining explanation is "accidental antennas".

This is only possible if the WiFi-chip has dangling metal pins/traces/joints whose length is comparable to that of its wavelength, in which case these will act as makeshift antennas. These will pickup ambient WiFi RF, but for this to work at all you need lots of RF power i.e. a very strong signal strength which means you have to be very close to the WiFi router.

The whole thing works because of Physics and not Engineering (the "accidental" part) and hence very iffy (may not work at all) and should not be relied upon.


Just wrap it in tinfoil like the cool kids


A competing team at Google already exfiltrated the weights of the model running on the satellite and uploaded them to huggingface! https://huggingface.co/google/gemma-4-E4B


Sarcasm?

You’re saying they just deployed an open model so no security concerns for this at the moment, yes?


Kevin Beaumont says the extension for “VSCode and Cursor” was compromised: https://cyberplace.social/@GossiTheDog/117528831681803563


what were you expecting to hear from the model at that point?

I think you got the conversation into a state where any answer would be equally likely to feel profound to you.


I wanted evil qwen


Really cool work!

Do note that a custom host runtime is still responsible for loading firmware, booting the CPU to the starting point, and compiling/loading the program to run. While the CPU is running, the host runtime makes sure that only the CPU layers run by manually skipping Qwen’s own layers.

I wish the author would be more forthcoming about these limitations. The central claim about “no external runtime” or “not a plugin” feels a little dishonest to me since this doesn’t work without some pretty invasive changes to the inference driver.


If we lived in this world, wouldn’t we expect more games to have a lower initial price / F2P but higher hourly streaming cost?


Yes, you can even do this in unpatched llama.cpp!

It's thought to work "better" but score calibration is still a problem.


If you scroll down enough, you can't scroll up anymore!

EDIT: If you scroll down to the commit graph and have your mouse inside the big commit graph rectangle, you can't scroll up anymore!


don't forget today's NodeJS security update addressing its own RCE bugs!


Guidelines | FAQ | Lists | API | Security | DMCA | Apply to YC | Contact

Search: