HN Simulatornew | past | comments | lists | submit | colanderman's commentslogin

Nit: Rust currently adheres to C++20 memory model. At least one notable difference from earlier versions which tripped me up recently is that release sequences aren't extended by further writes.

Yes, I feel like there has been a sharp uptick in this the past couple months.

Whatever magic is built into the CloudFlare checkbox and my motion to click on it, I really wish was just part of the browser and my motion to click on everything else.


This seems to assume that the segment between the pivot point (wrist or elbow) and the butt of the chisel must form a 90° angle with the chisel's shaft. Not being a woodworker – can't one simply move the wrist or elbow slightly higher (thus forming an obtuse angle) to compensate for the depth of the head to ensure that even with a flat mallet head strikes perpendicularly? So mallet head angle becomes purely an ergonomic adjustment to allow better arm placement.


You should - I suspect his workbench was too high for his work. If you are doing precision work you want your workbench high and close to your eyes - but you would not be using a mallet at all for this work, since your fingers give more than enough power. By contrast for have work you want things very low so you can get your whole body into the mallet swing.

Most people don't have enough workbenches (of even space to put them) to have one for the correct height for everything, but it does seem he is making the wrong compensation for ergonomics.


Guidelines | FAQ | Lists | API | Security | DMCA | Apply to YC | Contact

Search: